How to Pierce Your Ear With an Earring Without Pain

Download Article

Download Article

While the result of piercing your ears is glamorous, actually piercing your ears at home can be tricky and a bit risky. If you want to pierce your ears rather than go to a professional, follow these steps to pierce your ears safely and properly. Ask your parents before you try piercing your ears if you're a minor.

1. 1

   Use pre-packaged 70% isopropyl alcohol swabs to clean your ear. You must do this so that your ear is completely wiped clean of any bacteria that may have gotten into your piercing. Wait until the ear is dry to pierce it.^[1]

   • You can also use hydrogen peroxide or rubbing alcohol to sterilize your ear.

2. 2

   Make a mark where you want your piercing(s) to go. It is important to plan ahead for where you would like the piercing to go; otherwise your piercing might end up crooked, too high, or too low. If you are piercing both of your ears, look in the mirror and make sure that the marks you have made on your ears are even.

   • If you have other piercings and are doing your second or third piercing, make sure that you leave enough space in between piercings so that you can wear studs in both holes without the earrings overlapping. Likewise, don't make your holes too far apart or they may look odd.

3. 3

   Get a sterile piercing needle. Piercing needles have a hollow center so you can easily slip your earring through your ear once you make a hole with the needle. Do not share needles with other people as this could lead to infection. Piercing needles can be cheaply obtained at many online vendors, as well at many piercing studios.^[2]

   • Make sure to use a needle that is one gauge bigger than the earring that you plan to wear. 16 gauge barbell studs combined with 15 gauge needles work well.
   • You can also choose to buy a piercing package, which comes with two sterilized piercing earrings that have been loaded into a spring puncher. You can purchase these at beauty supply stores. Make sure to follow the directions on the package exactly as they are written.

4. 4

   Pick out your piercing earrings. The best thing for newly pierced ears, whether it's through lobes or cartilage, are studs. 16 gauge and about 10mm long (3/8") is a good size; the length allows for swelling, which can easily double the thickness of your ear.

   • Some jewelry stores sell piercing earrings--these are earrings with a very sharp tip similar to a needle. These are good to use because they will re-pierce your ear as you slide it into the hole made by your needle.
   • If you can, purchase earrings of a higher quality metal such as silver or titanium. Metals of higher quality are less likely to infect your ear or cause an allergic reaction. Be aware that some people are allergic to lower quality metals like gold-plated metal.

5. 5

   Sterilize the needle with an open flame. Do not reuse someone else's needles; your needle should come in a sterile package. Hold it there until the tip becomes red hot. You should wear sterile latex gloves while doing this so as to make sure that any bacteria on your hands does not get on the needle. Be sure to remove any soot or detritus. Wipe the needle clean with 10%+ rubbing alcohol or hydrogen peroxide. Be forewarned, this will only be a partial sterilization and will not kill all the potential microbes that may be on the needle. The only way to completely sterilize piercing utensils is by using an autoclave.

   • You could also sterilize the needle by boiling water. Once the water is boiling, place the needle in the boiling water and let it stay there for 5 to 10 minutes. Remove it with tongs and only hold it with sterile latex gloves. Wipe the needle down with hydrogen peroxide or rubbing alcohol.

6. 6

   Wash your hands with soap and water. This will decrease any chance of bacteria of spreading. Put on sterile latex gloves after you have washed your hands.^[3]

7. 7

   Keep your hair away from the spot you are planning to pierce. Your hair might get stuck in between your ear and the earring, or it could get pushed through the hole you make with the needle. If possible, tie your hair up and away from your ear.

1. 1

   Find something sturdy to put against your ear. You need to have something against your ear so that you can push the needle through your ear without accidentally piercing your neck too. A cold, clean bar of soap or a cork are both good choices. Avoid apples or potatoes, even though that's generally what's used in the movies. Apples, potatoes, or any other food may have bacteria on it that could infect your piercing.^[4]

   • If possible, have a friend (or friends) help you with the piercing. Either have them hold the cork against the back of your ear or, if you trust them immensely, have them do the actual piercing. This whole process is much easier to do when you have someone there to help you.

2. 2

   Place the needle in the proper position. The needle should be perpendicular to your earlobe. This means that it should make a roughly 90-degree angle with the mark that you made on your ear. Positioning the needle this way will allow it to slide more effectively through your ear.

3. 3

   Take a deep breath and stick the piercing needle smoothly through your ear. Make sure it goes through the spot you have marked. You may hear a popping noise when the needle goes through--don't freak out! Wiggle the needle, then keep it bent at an angle. If you are using a hollow piercing needle, thread the jewelry through the center of the needle.

4. 4

   Put the earring in your ear. After you've pierced your ear, and while the needle is sticking through the ear, place the shaft of the earring into the hollow tube of the needle and then push it all the way through the ear. This will leave the earring sitting comfortably in the new hole.

5. 5

   Remove the piercing tool. Slowly remove the needle from your ear, making sure that the earring stays in place. Be aware that this will most likely be painful, but try not to rush it, as you don't want the earring to fall out or else you will have to go through the piercing process again.

   • Be aware that the hole you have made could close up in minutes if left without an earring in it. If your earring falls out, resterilize it as quickly as possible and try to fit it back through the hole. If it does not go through, you may have to pierce your ear again.

1. 1

   Leave the earring in for six weeks. You should not take your earring out at any point. After the six weeks have passed, you can switch the earring out, but replace it with another earring immediately. It often takes six months to a whole year for the hole to fully take shape and not close up when you leave it without an earring for any duration of time.^[5]

2. 2

   Wash the piercing daily. Wash your ear with a warm saline solution.^[6] Use sea salt or Epsom salt rather than normal table salt. The salt cleans out the piercing and keeps the hole from getting infected. Clean the piercing until it is fully healed (up to approximately six weeks). Don't use rubbing alcohol once the ear is pierced.^[7]

   • An easy way to clean your ear is to find a small cup about the same size as your ear and put the salt water solution into that. Put a towel under the cup (to catch any overflow) and then lay on the couch and lower you ear slowly into the warm, salty water. 5 minutes of that and your ear will be feeling as good as new! "1 cup/250ml" measuring cups work well for this.
   • You can also dip a cotton swab in the warm salt water solution and rub it around and against the piercing.
   • There are also antiseptic solutions specifically made for newly pierced ears. You can buy them at beauty supply stores. Again, dip a cotton swab in the solution and then rub it in and around the piercing once a day.

3. 3

   Rotate your earring when you clean it. Hold onto the stud part of the earring (the part in the front of your ear) and twist it so that it rotates in the hole. This will open up the hole you have made in your ear and will keep the hole from closing too tightly around the earring.

4. 4

   Remove your piercing earrings and put new earrings in. Do this only after six weeks have passed. Put the new earrings immediately after taking the original earring out and cleaning the hole.

   • It is best if your earrings are made of 100% surgical steel, titanium, or niobium, as these materials are not as prone to causing infection as cheaper materials.

Add New Question

• Question

  Will it hurt when I put the needle in?

  

  Yes, but it also depends on your own pain tolerance. Most people liken the pain to getting pinched.

• Question

  Can I switch I earrings early as long as I clean it and always have an earring in?

  

  No, you should only switch earrings after 5 to 6 weeks. Otherwise, the hole won't heal as fast as it would if you had left it in.

• Question

  Does it look weird if it closes up?

  

  CuteUnicorn

  Community Answer

  No, it ends up looking like a small scar the size of the needle you pierced it with.

• Question

  Can I use a regular sewing needle?

  

  You could, but a safety pin is typically thicker and sharper, which makes the process easier and makes it less painful to put earrings in afterward.

• Question

  Is it normal if the ear lobe is a little swollen just after piercing it?

  

  Yes. They may be a bit swollen for a few weeks while they are healing.

• Question

  What should I do if I pierce it incorrectly and have to go to the hospital?

  

  You can have doctor treat it, wait for it to heal, and get it done again professionally.

• Question

  "Washing the piercing" is recommended. Should this be done with the earring in or out?

  

  Amelia Schroeder

  Community Answer

  For six weeks, it should be done with the earring in. Afterwards, it should be done with the earring out.

• Question

  Do you have to take the piercing out when you wash it with salt and water?

  

  No, you shouldn't remove the earring for six to eight weeks.

• Question

  Can gold be used as a starter earring?

  

  Yes. Gold is generally a good starter earring, just make sure it isn't gold plated.

• Question

  How fast is the process of piercing my ear?

  

  Preparation can take a long time; the longer the better really. However, putting the needle through should be done as quickly as possible, and jewellery should be put in immediately after. Taking a long time will cause a natural inflammatory response and the needle may get stuck halfway through (which would be painful).

Show more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

• Make sure that you use a pillow that does not have loose fabric when you go to bed. If the fabric is loose, your earring may get caught on it, which would hurt a lot.

• Take Advil or some other pain reliever roughly half an hour before piercing your ear(s) so as to reduce the pain you will feel after. Some people believe that taking such painkillers before getting a piercing will hinder your body's ability to clot the piercing area. Take at your own risk.

• There is some debate about whether to rotate your piercing regularly or not. If you don't, it could grow connected to the earring and cause discomfort when you try to remove it. However, rotating can also slow healing or push debris into the hole, making it more prone to infection. If you choose to rotate, do it with care, and only when you're cleaning it.

• Don't think about the piercing as this will make it hurt more.

• Numb your ear with an ice cube for 5 minutes before you pierce it. It makes it a lot less painful.

• To clean your ear better, use a Q-tip to get around the earring and into hard to reach places.

• Don't take Aspirin or medication like it before piercing your ear; it thins your blood and may prevent the forming of a clot in your ear.

• Try not to rub the solution when cleaning it, try to dab the solution on.

• Salt water is the best way to clean your ears because other materials like witch hazel, rubbing alcohol and Claire's solution will get rid of good and bad bacteria. You can also use plain dove soap because it's for sensitive skin.

Thanks for submitting a tip for review!

• Having your ear pierced by a professional is often much less tedious than doing it yourself.

• Don't let your piercing become infected! If it does, do not remove the piercing! Doing so will seal the infection within the earlobe, which can cause many problems, such as an abscess. Rinse your ear continually with warm salt water. If the infection persists, see a doctor.

• Unless you actually know what you're doing, go to a professional and don't pierce yourself with a gun, safety pin or old ear piercing earrings. Safety pins are not made of the correct (or safe) material for piercing. Piercing guns can not be properly sterilized and the jewelry used is inserted using blunt force trauma that will kill the tissue in your ear.

About This Article

Article SummaryX

Before you pierce your ear, use a pre-packaged 70% isopropyl alcohol swab to clean your ear, so bacteria doesn't get into the piercing. Once your ear is clean and dry, use a marker to dot where you want to the piercing to be. Make sure you wash your hands with soap and water before you pierce your eat to prevent spreading bacteria. You can also put on latex gloves for extra protection. When you're ready to pierce your ear, hold an object, like a clean cork or bar of soap, against the back of your ear to catch the needle when it pierces through. Then, carefully push a sterilized, hollow piercing needle though the dot on your ear until it goes all the way through the skin. Once it's through your ear, thread your new earring through the end of it to pull it through the piercing. To learn how to take care of your new piercing, read on!

Did this summary help you?

Thanks to all authors for creating a page that has been read 2,714,849 times.

Did this article help you?

How to Pierce Your Ear With an Earring Without Pain

Source: https://www.wikihow.com/Pierce-Your-Ear

Share this post